Arctic Cat 350 2011 Service Manual page 102

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
Separating Crankcase
Halves
1. Remove the left-side and right-side cap screws
securing the crankcase halves noting the position
of the different-sized cap screws for joining pur-
poses.
2. Using Crankcase Separator/Crankshaft Remover
and tapping lightly with a rubber mallet, separate
the crankcase halves. Account for two alignment
pins.
NOTE: To keep the shaft/gear assemblies intact
for identification, tap the shafts toward the
left-side crankcase half when separating the
halves.
MD1006
MD1012
CC869
www.mymowerparts.com
Manual
Table of Contents
Disassembling
Crankcase Half
NOTE: To aid in installing, it is recommended that
the assemblies be kept together and in order.
NOTE: For steps 1-6, refer to illustration FI639A.
1. Remove the secondary driven shaft assembly (A)
noting the location of the front and rear bearing
locating pins and the center bearing locating ring.
Section
Table of Contents
MD1313
3
FI639A
FI660A
3-77