Arctic Cat 350 2011 Service Manual page 120

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
NOTE: Check float height by placing the carbure-
tor on its side w/float contacting the needle; then
measure with a caliper the height when the float
arm is in contact with the needle valve. Float arm
height should be 17 mm.
6. Place the float chamber into position making sure
the O-ring is properly positioned; then secure with
the Phillips-head screws.
KC0024
KC0035
KC0063A
www.mymowerparts.com
Manual
Table of Contents
7. Place the U-ring into the pump housing. Position
the spring and diaphragm assembly (lip toward the
carburetor) onto the carburetor; then secure the
assembly with the pump housing and three screws.
Tighten securely.
CAUTION
It is important to press down on the pump housing
until it contacts the carburetor to make sure the dia-
phragm lip is properly seated in the groove in the car-
buretor. If the diaphragm is not properly seated,
leakage will occur.
8. Place the jet needle, spring seat, and spring into
the vacuum piston; then place the assembly down
into the carburetor.
9. Place the top cover into position; then secure with
the Phillips-head screws. Tighten securely.
Section
Table of Contents
KC0022A
4
CC748
CC746
4-7