Arctic Cat 350 2011 Service Manual page 20

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
CHECKING/ADJUSTING
HEADLIGHT AIM
The headlights can be adjusted vertically and horizon-
tally. The geometric center of the HIGH beam light
zone is to be used for vertical and horizontal aiming.
1. Position the ATV on a level floor so the headlights
are approximately 6.1 m (20 ft) from an aiming
surface (wall or similar aiming surface).
NOTE: There should be an average operating
load on the ATV when adjusting the headlight aim.
2. Measure the distance from the floor to the
mid-point of each headlight.
3. Using the measurements obtained in step 2, make
horizontal marks on the aiming surface.
4. Make vertical marks which intersect the horizontal
marks on the aiming surface directly in front of the
headlights.
5. Switch on the lights. Make sure the HIGH beam is
on. DO NOT USE LOW BEAM.
6. Observe each headlight beam aim. Proper aim is
when the most intense beam is centered on the ver-
tical mark 5 cm (2 in.) below the horizontal mark
on the aiming surface.
7. Adjust each headlight by turning the adjuster
screw clockwise to raise the beam or counter-
clockwise to lower the beam.
2-12
ATV-0070C
KC406A
www.mymowerparts.com
Manual
Table of Contents
Shift Lever
CHECKING ADJUSTMENT
With the engine stopped and the brake lever lock
engaged, turn the ignition switch to the ON position;
then shift the transmission into each of the gear posi-
tions and note that the gear position indicated on the
LCD corresponds to the gear position selected by the
lever.
If the indicator does not correspond to the selected
gear, it will be necessary to test drive the ATV to deter-
mine if the gear position switch is faulty or the shift
lever needs adjustment.
If the ATV functions in the gear selected by the shift
lever, troubleshoot the gear position switch (see Elec-
trical System).
If the ATV functions but the shift lever does not corre-
spond with the gear indicated on the LCD, adjust the
shift linkage. To adjust, proceed to ADJUSTING.
ADJUSTING
1. Remove the seat; then remove the left-side engine
cover.
2. With the ignition switch in the ON position, loosen
jam nut (A) (left-hand threads); then loosen jam
nut (C) and with the shift lever in the reverse posi-
tion, adjust the coupler (B) until the transmission
is in reverse and the "R" icon appears on the LCD.
Section
Table of Contents
KC165
KC194A