For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
NOTE: If the slow jet is obstructed, the mixture
will be extremely lean at idle and part-throttle
operation.
11. Inspect the float valve for wear or damage.
12. Inspect the carburetor mounting flange for damage
and tightness.
ASSEMBLING
1. Thread the idle adjust screw into the carburetor
making sure the washer and spring are properly
positioned.
2. Install the pilot screw, spring, washer, and O-ring.
NOTE: Turn the pilot screw clockwise until it is
lightly seated; then turn it counterclockwise the
recommended number of turns as an initial setting.
NOTE: Note the locations of the jets and holder
during assembling procedures.
4-6
KC0029A
KC0028A
www.mymowerparts.com
CC761A
Manual
Table of Contents
3. Install the starter jet and slow jet. Tighten securely.
4. Install the main jet into the needle jet holder and
tighten securely; then install the needle jet and
needle jet holder assembly into the carburetor and
tighten securely.
5. Place the float assembly (with float valve) into
position and secure to the carburetor with the float
pin.
Section
Table of Contents
KC0032A
KC0031
KC0030A