Measuring/Adjusting Toe-Out - Arctic Cat 350 2011 Service Manual

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
4. Inspect threads for stripping or damage.
ASSEMBLING AND INSTALLING
1. Install the bearing; then install the snap ring mak-
ing sure it seats into the knuckle.
2. Install the knuckle to the upper and lower ball
joints and secure with the two cap screws. Tighten
to 35 ft-lb.
3. Install the tie rod end and secure with the nut.
Tighten to 30 ft-lb; then install a new cotter pin
and spread the pin.
NOTE: During assembling, new cotter pins
should be installed.
4. Apply a small amount of grease to the hub splines.
5. Install the hub assembly onto the splines of the
shaft.
6. Secure the hub assembly with the nut. Tighten
only until snug.
PR287A
KC313A
www.mymowerparts.com
Manual
Table of Contents
7. Secure the brake caliper to the knuckle with the
"patch-lock" cap screws. Tighten to 20 ft-lb.
8. Pump the hand brake lever; then engage the brake
lever lock.
9. Secure the hub nut (from step 6) to the shaft.
Tighten to 200 ft-lb.
10. Install a new cotter pin and spread the pin to
secure the nut.
11. Install the wheel; then using a crisscross pattern,
tighten to 40 ft-lb.
12. Remove the ATV from the support stand.
Measuring/Adjusting
Toe-Out
1. Thoroughly wash the ATV to remove excess
weight (mud, etc.).
2. Refer to the specifications and ensure the tires are
properly inflated to the recommended pressure.
NOTE: Ensure the inflation pressure is correct in
the tires or inaccurate measurements can occur.
3. Place the ATV in a level position taking care not to
push down or lift up on the front end; then turn the
handlebar to the straight ahead position.
Section
Table of Contents
KC305
KC283
8
8-5