Arctic Cat 350 2011 Service Manual page 109

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
NOTE: The countershaft assembly is now ready
to be installed.
Assembling Crankcase
Half
NOTE: For ease of assembly, install components
on the right-side crankcase half.
NOTE: If the output shaft was removed, make
sure that the proper shim is installed.
1. Install the output shaft into the crankcase making
sure the two gears, shim, washer, and nut are in the
correct order.
3-84
FI663
FI662
MD1199
www.mymowerparts.com
Manual
Table of Contents
2. Install and tighten the output shaft flange nut to 59
ft-lb. Using a punch, peen the nut.
3. Apply a liberal amount of oil to the crankshaft
bearing. Using a propane torch, heat the bearing
until the oil begins to smoke; then slide the crank-
shaft assembly into place.
NOTE: If heating the bearing is not possible, the
crankshaft can be installed using a crankshaft
installer.
4. Rotate the crankshaft so the counterweight is
toward the rear of the engine. Install the crank bal-
ancer shaft.
Section
Table of Contents
MD1079
MD1333
MD1334