Arctic Cat 350 2011 Service Manual page 124

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all gas tank components with parts-cleaning
solvent.
2. Inspect all hoses for cracks or leaks.
3. Inspect tank cap and tank for leaks, holes, and
damaged threads.
INSTALLING
1. Using a block to hold the front body open, place
the gas tank into position in the frame making sure
the heat shield is in position.
KC262
KC262
KC252A
www.mymowerparts.com
Manual
Table of Contents
2. Using a suitable block, support the rear of the tank
and connect the gasline hose to the gas tank valve
outlet. Secure with a clamp (350).
3. Remove all blocking and secure the gas tank with
the cap screw. Tighten securely; then connect the
gasline connector to the fuel pump outlet (425).
4. Secure the rear of the front body to the frame with
the cap screws (A) and tighten securely; then
install the gas tank cover and secure with the rein-
stallable rivets (B).
5. Install the side panels and seat making sure it locks
securely in place. Install the gas tank valve knob
(350); then, turn the gas tank valve to the ON posi-
tion (350) or connect the negative battery cable
(425) and check for leaks.
Section
Table of Contents
KC241A
4
KC225A
KC219A
4-11