Arctic Cat 350 2011 Service Manual page 90

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
Servicing Left-Side
Components
INSPECTING STARTER
CLUTCH/GEAR
1. Place the starter clutch gear onto the rotor/fly-
wheel and attempt to rotate the starter clutch gear
clockwise. It should lock up to the rotor/flywheel.
Rotate the gear counterclockwise and it should
turn freely. If it moves or locks up both ways, the
starter clutch must be replaced.
2. Inspect the starter clutch gear for chipped or miss-
ing teeth or discoloration/scoring of the clutch sur-
face. Inspect the bearing for loose, worn, or
discolored rollers. If bearing is damaged, it must
be replaced.
3. Inspect the one-way bearing for chipped surfaces,
missing rollers, or discoloration. If any of the
above conditions exist, replace the starter clutch
assembly.
REPLACING STARTER CLUTCH
ASSEMBLY
1. Remove the cap screws securing the one-way
clutch assembly to the flywheel; then remove from
the flywheel.
FI569
FI572
www.mymowerparts.com
Manual
Table of Contents
2. Thoroughly clean the rotor/flywheel; then install
the new one-way clutch and secure with the cap
screws after applying a drop of red Loctite #271 to
the threads. Tighten to 26 ft-lb using a crisscross
pattern. Make sure the one-way bearing is installed
with the notches directed away from the rotor/fly-
wheel.
REPLACING STARTER GEAR
BEARING
1. Support the starter clutch gear in a press making
sure to support the hub around the entire circum-
ference; then using a suitable bearing driver, press
the bearing from the gear.
Section
Table of Contents
FI570
3
FI576A
FI578
3-65