For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
10. Install the spacer (1), shaft (2), reverse idler gear,
and washer (3).
11. Install the secondary output driveshaft assembly
into the crankcase half making sure the front and
rear bearing alignment pins are seated in the
recesses; then install the center carrier bearing
alignment C-ring.
3-86
FI646
FI641A
FI645
www.mymowerparts.com
Manual
Table of Contents
Joining Crankcase
Halves
1. Verify that the two alignment pins (A) are in place
and that both case halves are clean and grease free.
Apply Three Bond Sealant to the mating surfaces.
Place the right-side half onto the left-side half.
Section
Table of Contents
FI660A
FI659A
FI661A