Ignition Coil - Arctic Cat 350 2011 Service Manual

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
425
CAUTION
Always replace a blown fuse with a fuse of the same
type and rating.
 NOTE: The ignition switch must be in the LIGHTS
position.
1. Remove all fuses from the distribution module.
2. Set the meter selector to the DC Voltage position.
3. Connect the black tester lead to ground.
4. Using the red tester lead, contact each end of the fuse
holder connector terminals individually.
5. The meter must show battery voltage from one side
of the connector terminal ends.
 NOTE: Battery voltage will be indicated from only
one side of the fuse holder connector terminal; the
other side will show no voltage.
 NOTE: When testing the HI fuse holder, the head-
light dimmer switch must be in the HI position; when
testing the LIGHTS fuse holder, the headlight dimmer
switch can be in either position.
 NOTE: If the meter shows no battery voltage, trou-
bleshoot the battery, switches, distribution module,
or the main wiring harness.
CAUTION
Always disconnect the battery when performing resis-
tance tests to avoid damaging the multimeter.
1. Set the meter selector to the OHMS position.
5-6
2411-565
KC210A
www.mymowerparts.com
Manual
Table of Contents
2. Connect the red tester lead to one spade end of the
fuse; then connect the black tester lead to the other
spade end.
3. The meter must show less than 1 ohm resistance. If
the meter reads open, replace the fuse.
 NOTE: Make sure the fuses are returned to their
proper position according to amperage. Refer to the
fuse block cover for fuse placement.
RELAYS
The relays are identical plug-in type located on the power
distribution module. Relay function can be checked by
switching relay positions. The relays are interchangeable.
 NOTE: The module and wiring harness are not a service-
able component and must be replaced as an assembly.

Ignition Coil

The ignition coil is on the frame above the engine. To
access the coil, the left side panel must be removed.
RESISTANCE
CAUTION
Always disconnect the battery when performing resis-
tance tests to avoid damaging the multimeter.
 NOTE: For these tests, the meter selector should be
set to the OHMS position and the primary wire(s)
should be disconnected.
Primary Winding
1. Connect the red tester lead to either terminal; then
connect the black tester lead to the other terminal.
2. The meter reading must be within specification.
Secondary Winding
1. Remove the plug cap from the high tension lead; then
connect the red tester lead to the high tension lead.
2. Connect the black tester lead to ground.
3. The meter reading must be within specification.
 NOTE: If the meter does not show as specified,
replace ignition coil.
Spark Plug Cap
1. Connect the red tester lead to one end of the cap; then
connect the black tester lead to the other end of the cap.
Section
Table of Contents