Arctic Cat 350 2011 Service Manual page 92

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
2. Clean the bearing bores in the housing and inspect
closely for cracks or shiny areas indicating bearing
movement. Replace the housing if any of the
above are evident.
3. With a drop of red Loctite #271 around the bearing
bore, press a new bearing into the magneto cover
until the bearing is firmly seated in the bearing
bore.
Installing Left-Side
Components
A. Starter Clutch/Gear
B. Rotor/Flywheel
1. If removed, place the crankshaft bearing retainer
into position. Apply red Loctite #271 to the three
cap screws. Install and tighten the three cap screws
securely.
FI593
FI594
www.mymowerparts.com
Manual
Table of Contents
2. Install the starter motor and tighten the two cap
screws securely.
3. Install the shift detent cam making sure the washer
is installed.
4. Install the shift detent cam arm and spring.
5. Install the gear shift shaft assembly and washer
making sure to align the alignment marks.
6. Install starter idler gears (1) and (2).
Section
Table of Contents
MD1122
3
MD1086
FI559
3-67