Arctic Cat 350 2011 Service Manual page 48

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
22. Depress the spring-loaded lock and push the
plunger into the tensioner.
23. Place the cam chain tensioner assembly and gasket
into the cylinder making sure the ratchet side is
facing toward the top of the cylinder and secure
with the two cap screws.
24. Install the cap screw and spring into the end of the
cam chain tensioner. Tighten securely.
MD1248
MD1146
MD1254
www.mymowerparts.com
Manual
Table of Contents
25. Loosen the adjuster screw jam nuts; then loosen
the adjuster screws on the rocker arms in the valve
cover.
26. Apply a thin coat of Three Bond Sealant to the
mating surface of the valve cover; then place the
valve cover into position. Note that the two align-
ment pins are properly positioned.
NOTE: At this point, the rocker arms and adjuster
screws must not have pressure on them.
27. Install the four top-side cap screws with rubber
washers; then install the remaining cap screws.
Tighten only until snug.
28. In a crisscross pattern starting from the center and
working outward, tighten the cap screws (from
step 27) to 8 ft-lb.
29. Adjust valve/tappet clearance (see Periodic Main-
tenance).
30. Place the two tappet covers with O-rings into posi-
tion; then install and tighten the cap screws
securely.
Section
Table of Contents
MD1245
3
MD1261
3-23