Arctic Cat 350 2011 Service Manual page 59

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
12. Slide the fixed drive face assembly onto the front
shaft.
13. Spread the faces of the driven pulley by threading
a V-belt cover cap screw into the fixed driven face
and tightening until the faces open sufficiently to
allow the V-belt to drop into the pulley approxi-
mately 3/4 in.
NOTE: The arrows on the V-belt should point in
direction of engine rotation.
14. Making sure the movable drive face rollers are in
position, pinch the V-belt together near its center
and slide the spacer and movable drive face onto
the shaft.
3-34
MD1068
KC134
KC137
www.mymowerparts.com
Manual
Table of Contents
15. Coat the threads of the nut with red Loctite #271;
then making sure the splines of the clutch shaft
protrude through the cover plate, secure with the
nut and tighten to 147 ft-lb.
NOTE: At this point, the cap screw can be
removed from the driven pulley face.
16. Rotate the V-belt and drive/driven assemblies until
the V-belt is flush with the top of the driven pulley.
17. Install two alignment pins and place a new V-belt
cover gasket into position on the clutch cover. In a
crisscross pattern, tighten cap screws to 8 ft-lb.
Section
Table of Contents
KC127
KC138
KC141