Arctic Cat 350 2011 Service Manual page 97

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
NOTE: Always use a new snap ring when install-
ing the oil pump driven gear.
17. Remove oil pump driven gear. Account for the
drive pin and thrust washer.
 AT THIS POINT
To service clutch components,
Right-Side Components sub-section.
G. Oil Pump/Oil Strainer
NOTE: Steps 1-17 in the preceding sub-sections
must precede this procedure.
18. Remove three cap screws holding the oil pump
and remove the oil pump. Account for two align-
ment pins.
19. Remove the four cap screws securing the oil
strainer cap; then remove the Phillips-head screws
securing the oil strainer. Account for the O-ring.
3-72
MD1020
see Servicing
MD1060
www.mymowerparts.com
Manual
Table of Contents
 AT THIS POINT
To service center crankcase components only, pro-
ceed to Separating Crankcase Halves.
Servicing Right-Side
Components
NOTE: Whenever a part is worn excessively,
cracked, damaged in any way, or out of tolerance,
replacement is necessary.
INSPECTING CENTRIFUGAL
CLUTCH SHOE
1. Inspect the clutch shoe for uneven wear, chips,
cracks, or discoloration.
2. Inspect the depth of the grooves in the clutch
shoes. If any shoe is worn to the bottom of the
groove, replace the complete set.
CAUTION
Always replace clutch shoes as a complete set or
severe imbalance could occur.
Section
Table of Contents
MD1207