Table Of Contents - Arctic Cat 350 2011 Service Manual

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
8. Pull the steering knuckle away from the axle tak-
ing care not to damage the seals as the axle clears
the knuckle.
9. Support the axle to not allow it to drop or hang.
CAUTION
The axle must be supported. If the axle is allowed to
drop or hang, damage to the inner CV joint may occur.
10. Pull out on the axle until completely extended;
then push it back in approximately one half inch
and pull out sharply. Repeat until axle spline dis-
lodges from the gear case.
NOTE: In some instances it may be necessary to
use a pry-bar between the gear case housing and
axle coupler shoulder to dislodge the splines.
6-4
KC314
KC425A
KC426A
www.mymowerparts.com
Manual

Table of Contents

11. Remove the cap screws from the drive coupler
flange; then remove the upper and lower mounting
cap screws and remove the differential from the
frame.
Disassembling Input Shaft
NOTE: This procedure can be performed on a
rear gear case; however, some components may
vary from model to model. The technician should
use discretion and sound judgment.
1. Remove the cap screws securing the front drive
actuator and remove the actuator; then remove the
cap screws securing the pinion housing.
2. Using a rubber mallet, remove the housing.
Account for a gasket. On the 425, remove the fork,
collar, and spring. Note the location of all the com-
ponents for assembling purposes.
Section
Table of Contents
KC291A
CD102
CD103