Arctic Cat 350 2011 Service Manual page 58

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
6. Install the one-way clutch making sure that the
green dot or the word OUTSIDE is directed away
from the crankcase.
7. Install gear position switch spacer and switch
making sure to align the drive pin with the slot in
the shift shaft.
B. Clutch Cover
C. Fixed Drive Face
D. Movable Drive Face
NOTE: Steps 1-7 in the preceding sub-section
must precede this procedure.
8. Install two alignment pins and place the clutch
cover gasket into position. Install the clutch cover.
MD1286
KC325A
KC326B
www.mymowerparts.com
Manual
Table of Contents
9. Tighten the clutch cover cap screws to 8 ft-lb.
10. Install the air intake plate. Apply red Loctite #271
to the threads of the three Phillips-head cap
screws; then install and tighten securely.
11. Place the driven pulley assembly into position and
secure with the nut (threads coated with red Loc-
tite #271). Tighten to 147 ft-lb.
Section
Table of Contents
MD1115
3
MD1117
MD1342
3-33