Front Differential; Table Of Contents - Arctic Cat 350 2011 Service Manual

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
3. While holding the actuator firmly forward, tighten
the front cap screw to hold the actuator in place;
then install but do not tighten the two remaining
cap screws.
4. Loosen the front cap screw; then tighten the cap
screw on the driveshaft side.
NOTE: It is important to tighten this cap screw
while the others are loose to ensure proper seating
of the actuator.
5. Tighten the remaining cap screws; then connect
the electrical plug to the main harness.
6. Turn the ignition switch to the ON position and
check the operation by shifting the selector switch
several times.
7. Secure the wiring harness to the frame with a
nylon cable tie.
AG925
KC295A
AG926
www.mymowerparts.com
Manual

Table of Contents

Front Differential

REMOVING DIFFERENTIAL
1. Secure the ATV on a support stand to elevate the
wheels.
! WARNING
Make sure the ATV is solidly supported on the support
stand to avoid injury.
2. Remove the drain plug and drain the gear lubricant
into a drain pan; then reinstall the plug and tighten
to 45 in.-lb.
3. Remove the front wheels.
4. Pump up the hand brake; then engage the brake
lever lock.
5. Remove the cotter pin securing the hex nut; then
remove the hex nut.
6. Release the brake lever lock.
7. Remove the upper and lower ball joint cap screws
taking care not to strip the threads.
CAUTION
Apply pressure to hold the ball joint firmly in the
knuckle or the threads will be stripped when the retain-
ing cap screws are removed.
Section
Table of Contents
ATV0082A
6
AF628D
6-3