Arctic Cat 350 2011 Service Manual page 17

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
14. Inspect the area around the drain plug and oil filter
for leaks.
15. Install the left-side engine cover and the seat.
Front Differential/Rear
Drive Lubricant
When changing the lubricant, use approved SAE
80W-90 hypoid gear lube.
To check lubricant, remove the rear drive filler plug;
the lubricant level should be 1 in. below the threads of
the plug. If low, add SAE approved 80W-90 hypoid
gear lubricant as necessary.
To change the lubricant, use the following procedure.
1. Place the ATV on level ground.
2. Remove each fill plug.
3. Drain the lubricant into a drain pan by removing
the drain plug from each.
ATV-0100AA
KC0077A
www.mymowerparts.com
Manual
Table of Contents
4. After all the oil has been drained, install the drain
plugs and tighten to 45 in.-lb.
5. Pour the appropriate amount of approved SAE
80W-90 hypoid gear lubricant into the filler hole.
6. Install the fill plugs and tighten to 16 ft-lb.
NOTE: If the differential/rear drive oil is contami-
nated with water, inspect the drain plug, filler plug,
and/or bladder.
CAUTION
Water entering the outer end of the axle will not be
able to enter the rear drive unless the seals are dam-
aged.
Tires
TIRE SIZES
The ATV is equipped with low-pressure tubeless tires
of the size and type listed (see General Information).
Do not under any circumstances substitute tires of a
different type or size.
! WARNING
Always use the size and type of tires specified. Always
maintain proper tire inflation pressure.
Section
Table of Contents
ATV0082A
2
737-651B
2-9