Arctic Cat 350 2011 Service Manual page 23

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
4. Adjust the auxiliary brake (if necessary).
5. Verify that the brakelight illuminates when the
hand lever is compressed or the brake pedal is
depressed.
Checking/Replacing
V-Belt
REMOVING
1. Remove the seat and right-side engine cover; then
remove the cap screw securing the auxiliary brake
pedal to the frame. Account for a flat washer.
2. Slide the auxiliary brake pedal part way off the
pivot stud but do not remove; then remove the cap
screws from the V-belt housing and remove the
cover. Account for two alignment pins and a gas-
ket.
3. Remove the nut securing the movable drive face to
the clutch shaft; then remove the movable drive
face assembly being careful not to let the roller fall
out. Account for a bushing.
KC149A
KC142A
www.mymowerparts.com
Manual
Table of Contents
4. Thread a cap screw from the V-belt cover into the
driven pulley fixed face and push the movable face
open allowing the V-belt to drop down between
the pulley faces approximately 3/4 in.
5. Pinching the V-belt together in front of the driven
pulley, pull it forward and outward off the clutch
shaft; then remove it from the driven pulley.
Section
Table of Contents
KC127
2
KC128
KC137
2-15