Configuring Acs Servers - Dell PowerConnect W-AirWave 7.6 User Manual

2. After you have completed all fields, select Save. AirWave is now configured to gather rogue information from
WLSE rogue scans. As a result of this configuration, any rogues found by WLSE appear on the RAPIDS > List
page.
What Next?
Go to additional tabs in the AMP Setup section to continue additional setup configurations.
l
Complete the required configurations in this chapter before proceeding. Dell support remains available to you for
l
any phase of AirWave installation.

Configuring ACS Servers

This is an optional configuration. The AMP Setup > ACS page allows AirWave to poll one or more Cisco ACS
servers for wireless username information. When you specify an ACS server, AirWave gathers information about your
wireless users. Refer to
AirWave users.
Perform these steps to configure ACS servers:
1. Go to the AMP Setup > ACS page. This page displays current ACS setup, as illustrated in
Figure 31:
AMP Setup > ACS Page Illustration
2. Select Add to create a new ACS server, or select a pencil icon to edit an existing server. To delete an ACS server,
select that server and select Delete. When selecting Add or edit, the Details page appears, as illustrated in
32.
Figure 32:
AMP Setup > ACS > Add/Edit Details Page Illustration
3. Complete the settings on AMP Setup > ACS > Add/Edit Details.
52 | Configuring AirWave
"Setting Up Device Types" on page 46 if you want to use your ACS server to manage your
Table 35 describes these fields:
Dell PowerConnect W-AirWave 7.6 | User Guide
Figure 31.
Figure