Dell PowerConnect W-AirWave 7.6 User Manual page 78

Setting
Selected Device
Types
8. To assign dynamically a range of static IP addresses to new devices as they are added into the group, locate the
Automatic Static IP Assignment section on the Groups > Basic configuration page. If you select Yes in this
section, additional fields appear. Complete these fields as required.
values This section is only relevant for a small number of device types, and will appear when they are present.
Table 43:
Automatic Static IP Assignment Fields and Default Values
Setting
Assign Static IP
Addresses to
Devices
Start IP Address
Number of
Addresses
Subnet Mask
Subnet Gateway
Next IP Address
9. To configure Spanning Tree Protocol on WLC devices and Proxim APs, locate the Spanning Tree Protocol
section on the Groups > Basic configuration page. Adjust these settings as required.
settings and default values.
Table 44:
Spanning Tree Protocol Fields and Default Values
Setting
Spanning Tree
Protocol
Bridge Priority
66 | Configuring and Using Device Groups
Default Description
All Devices—AirWave displays all Group tabs and setting options.
l
Only devices in this group—AirWave hides all options and tabs that do not apply to the
l
devices in the group. If you use this setting, then to get the group list to display the
correct SSIDs for the group, you must Save and Apply on the group.
on this
Only devices on this AMP— hides all options and tabs that do not apply to the APs and
l
AMP
devices currently on AirWave.
Use system defaults—Use the default settings on AMP Setup > General
l
Selected device types—Allows you to specify the device types for which AirWave
l
displays Group settings.
This option appears if you chose to display selected device types, allowing you to select the
N/A device types to display group settings. Use Select devices in this group to display only
devices in the group being configured.
Default Description
Specify whether to enable AirWave to statically assign IP addresses from a specified range
to all devices in the Group. If this value is set to Yes, then the additional configuration fields
No
described in this table will become available.
none Sets the first address AirWave assigns to the devices in the Group.
none Sets the number of addresses in the pool from which AirWave can assign IP addresses.
none Sets the subnet mask to be assigned to the devices in the Group.
none Sets the gateway to be assigned to the devices in the Group.
Defines the next IP address queued for assignment. This field is disabled for the initial
none
Access Points group.
Default Description
Specify wehther to enable or disables Spanning Tree Protocol on Proxim APs.If this value
No is set to Yes, then the additional configuration fields described in this table will become
available.
Sets the priority for the AP. Values range from 0 to 65535. Lower values have higher
32768 priority. The lowest value is the root of the spanning tree. If all devices are at default the
device with the lowest MAC address will become the root.
Table 43 describes the settings and default
Table 44
Dell PowerConnect W-AirWave 7.6 | User Guide
describes the