Configuring Tacacs+ Authentication - Dell PowerConnect W-AirWave 7.6 User Manual

Figure 23:
AMP Setup > RADIUS > Add RADIUS Accounting Client Page Illustration
1. To specify the RADIUS authentication server or network, browse to the AMP Setup > RADIUS Accounting
page, select Add, illustrated in
2. Complete the following fields:
Table 23:
AMP Setup > Radius Accounting Fields and Default Values for LDAP Authentication
Setting
IP/Network
Nickname
Shared Secret
(Confirm)

Configuring TACACS+ Authentication

For TACACS+ capability, you must configure the IP/Hostname of the TACACS+ server, the TCP port, and the
server shared secret. This TACACS+ configuration is for AirWave users and does not affect APs or users logging
into APs.
1. Go to the AMP Setup > Authentication page. This page displays current status of TACACS+.
illustrates this page when neither TACACS+, LDAP, nor RADIUS authentication is enabled in AirWave.
Figure 24:
AMP Setup > Authentication Page Illustration for TACACS+
Dell PowerConnect W-AirWave 7.6 | User Guide
Figure 23, and provide the information in
Default Description
Specify the IP address for the authentication server if you only want to accept packets from
None one device. To accept packets from an entire network enter the IP/Netmask of the network
(for example, 10.51.0.0/24).
None Sets a user-defined name for the authentication server.
Sets the Shared Secret that is used to establish communication between AirWave and the
None
RADIUS authentication server.
Table 23.
Figure 24
Configuring AirWave | 37