Dell PowerConnect W-AirWave 7.6 User Manual page 83

1. Select the device group for which to define security settings from the Groups > List page.
2. Go to Groups > Security. Some controls on this page interact with additional AirWave pages.
illustrates this page and
Figure 41:
Groups > Security Page Illustration
Table 52:
Groups > Security Page Fields and Default Values
Setting
VLANs Section
VLAN Tagging and
Multiple SSIDs
Management VLAN ID
General Section
Create Closed Network
Block All Inter-client
Communication
EAP Options Section
Dell PowerConnect W-AirWave 7.6 | User Guide
Table 52 explains the fields and default values.
Default Description
This field enables support for VLANs and multiple SSIDs on the wireless
network. If this setting is enabled, define additional VLANs and SSIDs on the
Groups > SSIDs page. Refer to
Enabled
74. If this setting is disabled, then you can specify the Encryption Mode in the
Encryption section that displays. Refer to
settings for information on configuring Encryption.
This setting sets the ID for the management VLAN when VLANs are enabled in
AirWave. This setting is supported only for the following devices:
Proxim AP-600, AP-700, AP-2000, AP-4000
Untagged
l
Avaya AP-3, Avaya AP-7, AP-4/5/6, AP-8
l
ProCurve520WL
l
If enabled, the APs in the Group do not broadcast their SSIDs.
No NOTE: Creating a closed network will make it more difficult for intruders to
detect your wireless network.
If enabled, this setting blocks client devices associated with an AP from
communicating with other client devices on the wireless network.
No NOTE: This option may also be identified as PSPF (Publicly Secure Packet
Forwarding), which can be useful for enhanced security on public wireless
networks.
"Configuring Group SSIDs and VLANs" on page
Groups > Security Encryption Mode
Configuring and Using Device Groups | 71
Figure 41