Dell PowerConnect W-AirWave 7.6 User Manual page 120

Figure 72:
Device Setup > Add > Device Communications and Location Sections
3. Complete these Device Communications and Location settings for the new device.
the contents of this page. Settings may differ from device to device based on the type of device and the features
that the device supports. In several cases, the default values from any given device derive from the Device Setup
> Communication page.
Table 70:
Device Communication and Location Fields and Default Values
Setting
Name
IP Address
SNMP Port
SSH Port
Community
String (Confirm)
108 | Discovering, Adding, and Managing Devices
Default
None
None
161
22
Taken from Device Setup >
Communication
Description
User-configurable name for the AP (maximum of 20 characters).
IP address of the device. This field is required.
Port AirWave uses to communicate with the AP using SNMP.
For devices that support SSH, specify the SSH port number.
Community string used to communicate with the AP.
NOTE: The Community String should have RW (Read-Write) capability.
New, out-of-the-box Cisco devices typically have SNMP disabled and a
blank username and password combination for HTTP and Telnet. Cisco
Table 70 further describes
Dell PowerConnect W-AirWave 7.6 | User Guide