Dell PowerConnect W-AirWave 7.6 User Manual page 88

Setting
Enable VLAN Tagging
(Cisco WLC, Proxim,
Symbol only)
VLAN ID (1-4094)
Interface
SSID
Name
Maximum Allowed
Associations (0-2007)
Broadcast SSID (Cisco
WLC, Proxim and Symbol
4131 only)
Partial Closed System
(Proxim only)
Unique Beacon
(Proxim only)
Block All Inter-Client
Communication
5. Locate the Encryption area on the Groups > SSIDs page and adjust these settings as required.
describes the available encryption modes.
configuration settings for each mode.
Table 56:
Groups > SSIDs > Encryption Section Field and Default Values
Setting
Encryption Mode
76 | Configuring and Using Device Groups
Default Description
Enables or disables VLAN tagging. Displays if Specify Interface Name is set to
No.
Indicates the number of the VLAN designated as the Native VLAN, typically for
None management purposes. Displays if Specify Interface Name is set to No and
Enable VLAN Tagging is set to Yes.
management Sets the interface to support the SSID/VLAN combination.
Sets the Service Set Identifier (SSID), which is a 32-character user-defined
identifier attached to the header of packets sent over a WLAN. It acts as a
None password when a mobile device tries to connect to the network through the
AP, and a device is not permitted to join the network unless it can provide the
unique SSID.
None Sets a user-definable name associated with SSID/VLAN combination.
Indicates the maximum number of mobile users which can associate with the
255 specified VLAN/SSID.
NOTE: 0 means unlimited for Cisco.
For specific devices as cited, this setting enables the AP to broadcast the SSID
for the specified VLAN/SSID. This setting works in conjunction with the Create
Closed Network setting on the Groups > Security configuration page. Proxim
No
devices support a maximum of four SSIDs.
NOTE: This option should be enabled to ensure support of legacy users.
For Proxim only, this setting enables to AP to send its SSID in every beacon,
No
but it does not respond to any probe requests.
For Proxim only, if more than one SSID is enabled, this option enables them to
No
be sent in separate beacons.
Yes This setting blocks communication between client devices based on SSID.
Table 53
Default Description
Drop-down menu determines the level of encryption required for devices to
associate to the APs. The drop-down menu options are as follows. Each option
displays additional encryption settings that must be defined. Complete the
associated settings for any encryption type chosen:
No Encryption
l
No
Optional WEP—Wired Equivalent Privacy, not PCI compliant as of 2010
l
Encryption
Require WEP—Wired Equivalent Privacy, not PCI compliant as of 2010
l
Require 802.1x—Based on the WEP algorithm
l
Require Leap—Lightweight Extensible Authentication Protocol
l
802.1x+WEP—Combines the two encryption types shown
l
802.1x+LEAP—Combines the two encryption types shown
l
in "Configuring Group Security Settings" on page 70
Dell PowerConnect W-AirWave 7.6 | User Guide
Table 56
describes