Dell PowerConnect W-AirWave 7.6 User Manual page 128

Field
Configuration
Firmware
Licenses (Appears
for Dell
controllers )
Controller
(Appears for APs)
Mesh Gateway *
Mesh Mode*
Mesh ID *
View in Google
Earth*
Type
Last Contacted
Uptime
LAN MAC
Address
Serial
Radio Serial
Location
Contact
IP Address
116 | Discovering, Adding, and Managing Devices
Description
ping the AP. This usually means AirWave is blocked from connecting to the AP or the AP needs to be
rebooted or reset.
Good means all the settings on the AP agree with the settings AirWave wants them to have.
l
Mismatched means there is a configuration mismatch between what is on the AP and what
l
AirWave wants to push to the AP. The Mismatched link directs you to this specific APs/Devices >
Audit page where each mismatch is highlighted.
Unknown means the device configuration has not yet been fetched (possible issue with credentials).
l
Verifying means that the device is fetching a configuration that will be compared to the desired
l
settings.
Error indicates a problem with the device. This configuration is accompanied with a description of
l
the error.
Displays the firmware version running on the AP.
Newer AirMesh APs include the new bootloader APBoot. AirWave helps to identify the new AirMesh
APs from the old SKUs by displaying the bootloader information here.
Selecting this link opens a pop-up window that lists the built-in licenses as well as other installed
licenses for this controller. This also shows whether any license has expired.
Displays the controller for the associated AP device as a link. Select the link to display the APs/Devices
> Monitor page for that controller.
Specifies the mesh AP acting as the wired connection to the network.
Specifies whether the AP is a portal device or a mesh node. The portal device is connected to the
network over a wired connection. A node is a device downstream of the portal that uses wireless
connections to reach the portal device.
The name of the mesh device.
Selecting the Google Earth icon opens the mesh network view in Google Earth.
Displays the make and model of the device.
Displays the most recent time AirWave has polled the AP for information. The polling interval can be set
on the Groups > Basic page.
Displays the amount of time since the AP has been rebooted. This is the amount of time the AP reports
and is not based on any connectivity with AirWave.
Displays the MAC address of the Ethernet interface on the device.
Displays the serial number of the device.
Displays the serial number of the radios in the device. This field is not available for all APs.
Displays the SNMP location of the device.
Displays the SNMP contact of the device.
Displays the IP address that AirWave uses to communicate to the device. This number is also a link to
the AP web interface. When the link is moused over a pop-up menu will appear allowing you to http,
https, telnet or SSH to the device.
Dell PowerConnect W-AirWave 7.6 | User Guide