Configuring Single And Dual-Radio Aps Via A Single Ios Template; Configuring Cisco Catalyst Switch Templates; Configuring Symbol Controller / Hp Wesm Templates - Dell PowerConnect W-AirWave 7.6 User Manual

Configuring Single and Dual-Radio APs via a Single IOS Template

To configure single and dual-radio APs using the same IOS config template, you can use the interface variable within
the %IF...% construct. The below example illustrates this usage:
%IF interface=Dot11Radio1%
interface Dot11Radio1
bridge-group 1
bridge-group 1 block-unknown-source
bridge-group 1 spanning-disabled
bridge-group 1 subscriber-loop-control
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
no ip address
no ip route-cache
rts threshold 2312
speed basic-6.0 basic-9.0 basic-12.0 basic-18.0 basic-24.0 36.0 48.0 54.0
ssid decibel-ios-a
authentication open
guest-mode
station-role root
%ENDIF%

Configuring Cisco Catalyst Switch Templates

Cisco Catalyst Switch templates are configured much like Cisco IOS templates with the addition of the
and
interfaces
Interface pages, as shown in
information as described in this section or by fetching a template from that device, as described in
General Templates" on page
NOTE: Just one template is used for any type of Cisco IOS device, and another is used for any type of Catalyst Switch regardless of
individual model.

Configuring Symbol Controller / HP WESM Templates

This section describes the configuration of templates for Symbol controllers and HP WESM devices.
Symbol controllers (RFS x000, 5100 and 2000) can be configured in AirWave using templates. AirWave supports
Symbol thin AP firmware upgrades from the controller's manage page.
A sample running-configuration file template is provided in this topic for reference. A template can be fetched from
a model device using the Cisco IOS device procedure described in
Cisco IOS template directives such as
Certain parameters such as
values can be read from the individual manage pages and inserted into the template. They are listed in Available
Variable boxes on the right-hand side of the template fields.
Certain settings have integrated variables, including
preamble has been template-integrated as well. An option on the Group > Templates page reboots the device after
pushing a configuration to it.
A sample Symbol controller partial template is included below for reference.
!
! configuration of RFS4000 version 4.2.1.0-005R
!
164 | Creating and Using Templates
(for stacked switches) variables. Interfaces can be configured on the Device
switch_command
"Configuring Device Interfaces for Switches" on page
155.
ignore_and_do_not_push
and
hostname location
"Configuring Cisco IOS Templates" on page
can also be applied to Symbol templates.
are turned into variables with the
and
ap-license adoption-preference-id
Dell PowerConnect W-AirWave 7.6 | User Guide
139. You can import interface
"Configuring
tags so that device-specific
%
. The radio
162.