Initial Wlse Configuration; Adding An Acs Server For Wlse; Enabling Rogue Alerts For Cisco Wlse; Configuring Wlse To Communicate With Aps - Dell PowerConnect W-AirWave 7.6 User Manual

Initial WLSE Configuration

Use the following general procedures to configure and deploy a WLSE device in AirWave:
"Adding an ACS Server for WLSE" on page 48
l
"Enabling Rogue Alerts for Cisco WLSE" on page 48
l
"Configuring WLSE to Communicate with APs" on page 48
l
"Discovering Devices" on page 48
l
"Managing Devices" on page 49
l
"Inventory Reporting" on page 49
l
"Defining Access" on page 49
l
"Grouping" on page 49
l

Adding an ACS Server for WLSE

1. Go to the Devices > Discover > AAA Server page.
2. Select New from the drop-down list.
3. Enter the Server Name, Server Port (default 2002), Username, Password, and Secret.
4. Select Save.

Enabling Rogue Alerts for Cisco WLSE

1. Go to the Faults > Network Wide Settings > Rogue AP Detection page.
2. Select the Enable.
3. Select Apply.
Additional information about rogue device detection is available in
page 50.

Configuring WLSE to Communicate with APs

1. Go to the Device Setup > Discover page.
2. Configure SNMP Information.
3. Configure HTTP Information.
4. Configure Telnet/SSH Credentials
5. Configure HTTP ports for IOS access points.
6. Configure WLCCP credentials.
7. Configure AAA information.

Discovering Devices

The following three methods can be used to discover access points within WLSE:
Using Cisco Discovery Protocol (CDP)
l
Importing from a file
l
Importing from CiscoWorks
l
Perform these steps to discover access points.
1. Go to the Device > Managed Devices > Discovery Wizard page.
2. Import devices from a file.
3. Import devices from Cisco Works.
4. Import using CDP.
48 | Configuring AirWave
"Configuring Cisco WLSE Rogue Scanning" on
Dell PowerConnect W-AirWave 7.6 | User Guide