Cisco Wlc Group Configuration; Accessing Cisco Wlc Configuration - Dell PowerConnect W-AirWave 7.6 User Manual

Hide thumbs Also See for PowerConnect W-AirWave 7.6:
Table of Contents

Advertisement

Table 62:
Groups > Radio > Proxim 4900M Fields and Default Values
Setting
4.9GHz Public Safety
Channel Bandwidth
802.11a/4.9GHz Public
Safety Operational
Mode
7. To configure Symbol-only settings, locate the Symbol section and define the required fields.
the settings and default values.
Table 63:
Groups > Radio > Symbol Fields and Default Values
Setting
Rogue Scanning
Rogue Scanning
Interval (5-480 min)
8. Select Save when radio configurations as described above are complete, select Save and Apply to make the
changes permanent, or select Revert to discard all unapplied changes.

Cisco WLC Group Configuration

The Groups > Cisco WLC Config page consolidates the settings for Cisco WLC devices from all group pages. The
Groups > SSIDs subtab applies to all device types except for Cisco WLC, which have WLANs configured on the
Cisco WLC Config page. It is not recommended to have Symbol 4131 and Proxim APs in the same group as Cisco
devices. Also, it is recommended that users set device preferences to Only devices in this group. This topic
describes how to access and navigate the Groups > Cisco WLC Config page.

Accessing Cisco WLC Configuration

Go to the Cisco WLC Config page in one of these two ways:
1. In Groups > List, select a group that has been defined to support Cisco devices. The Cisco WLC Config option
appears in the subtabs.
2. In Groups > List, create a new group to support Cisco devices with these steps:
Select Add from the Groups > List page to create a new group, enter a group name, and select Add.
n
Once AirWave prompts you with the Groups > Basic page, ensure that you enable device-specific settings for
n
Cisco WLC.
After you select Save or Save and Apply, the Groups > Cisco WLC Config subtab appears in the navigation
n
pane at the top in association with that group.
Dell PowerConnect W-AirWave 7.6 | User Guide
Default
Description
This setting specifies the channel bandwidth for the 4.9 GHz radio. It is only
20
applicable if you are running the 802.11a/4.9GHz radio in 4.9GHz mode.
This setting specifies if the AP will run the 802.11a/4.9GHz radio in 802.11a mode or
802.11a
in 4.9 GHz mode. Please note that 4.9 GHz is a licensed frequency used for public
safety.
Default
Description
If enabled, Symbol access points with 3.9.2 or later firmware in the group will passively
Yes
scan for rogue access points at the specified interval. This rogue scan will not break a
user's association to the network.
If Rogue Scanning is enabled, this setting controls the frequency with which scans are
240
conducted (in minutes). Frequent scans provide the greatest security, but AP performance
and throughput available to user devices may be impacted modestly during a rogue scan.
Table 63
describes
Configuring and Using Device Groups | 81

Advertisement

Table of Contents
loading

Table of Contents