Dell PowerConnect W-AirWave 7.6 User Manual page 80

NOTE: When configuring Cisco WLC controllers, refer to
13. To configure settings specific to Aruba locate the Aruba section and adjust these settings as required.
describes the settings and default values of this section.
Table 48:
Aruba Fields and Default Values
Setting
SNMP Version
Offload WMS
Database
Dell
PowerConnect W
GUI Config
Ignore Rogues
Discovered by
Remote APs
Delete Certificates
On Controller
14. To configure settings for 3Com, Enterasys, Nortel, or Trapeze devices, locate the
3Com/Enterasys/Nortel/Trapeze section and define the version of SNMP to be supported.
15. To configure settings for universal devices on the network, including routers and switches that support both wired
and wireless networks, locate the Universal Devices, Routers and Switches section of the Groups > Basic page
and define the version of SNMP to be supported.
16. To control the conditions by which devices are automatically authorized into this group, locate the Automatic
Authorization settings section and adjust these settings as required.
values.
Table 49:
Automatic Authorization Fields and Default Values
Setting
Add New Controllers
and Autonomous
Devices Location
Add New Thin APs
Location
68 | Configuring and Using Device Groups
Default Description
2c The version of SNMP used by AirWave to communicate to the AP.
Configures commands previously documented in the Dell PowerConnect W-AirWave Best
Practices Guide. When enabled, this feature allows AirWave to display historical
information for WLAN switches.
No Changing the setting to Yes pushes commands via SSH to all WLAN switches in Monitor
Only mode without rebooting the controller. The command can be pushed to controllers in
manage mode (also without rebooting the controller) if the Allow WMS Offload setting on
AMP Setup > General is changed to Yes.
This setting selects whether you'd like to configure your Aruba devices using the
Yes Groups > Dell PowerConnect W Config method (either global or group) or using
Templates.
Configures whether to turn off RAPIDS rogue classification and rogue reporting for RAPs in
No
this group.
No Specifies whether to delete the current certificates on an ArubaOS controller.
Default Description
Whether to auto authorize new controllers to the New Devices List, the same
Use Group/Folder as the discovering devices, the same Group/Folder as the closest IP
Global neighbor, and/or a specified auto-authorization group and folder. The Current Global
Setting set in AMP Setup > General is shown below this field. Selecting a different
Setting
option overrides the global setting.
Whether to auto authorize new thin APs to the New Devices List, the same
Use Group/Folder as the discovering devices, the same Group/Folder as the closest IP
Global neighbor, and/or a specified auto-authorization group and folder. The Current Global
Setting Setting set in AMP Setup > General is shown below. Selecting a different option
overrides the global setting for this group.
"Configuring Wireless Parameters for Cisco Controllers" on page
Table 49 describes the settings and default
Dell PowerConnect W-AirWave 7.6 | User Guide
87.
Table 48