Adding A Wiring Closet - Dell PowerConnect W-AirWave 7.6 User Manual

4. Move the location probability slider to the desired level, as shown on
probability of a device being placed in that region by 20%. Very High will increase the probability of a device
being placed in that region by 20%.
Figure 212:
Adding a New Location Probability Region
5. Optionally, you can save the location region as the exterior walls. 100% attenuation can be selected to force
VisualRF to only place devices inside of the selected region. No device will ever be placed outside of the
probability region when 100% attenuation is selected. 100% attenuation is only recommended for tall buildings
where it is extremely unlikely that any user is located outside of the building. No heat map or attenuation grid is
calculated for devices outside of the 100% attenuation region.

Adding a Wiring Closet

To add a Wiring Closet to VisualRF, follow these steps:
1. In the Edit menu, select the Draw Region option.
2. Outline the desired region. Double click or press Ctrl+click to end the outline process.
3. Name the region, select a Region Type of Wiring Closet, and select OK, as shown in
Figure 213:
Adding a new Wiring Closet Region
286 | Using VisualRF
Figure 212. Very Low will decrease the
Figure 213.
Dell PowerConnect W-AirWave 7.6 | User Guide