Tweaking A Planning Region - Dell PowerConnect W-AirWave 7.6 User Manual

Table 149:
Fields in the Autoprovision APs Window
Field
Device Selection
AP Type
Radio Section
Phy
Xmit
Gain
EIRP
Environment
Plan By Section
Coverage
Location
Number of APs
Client Info Section
Enable
Total clients in region
Max clients per radio
Plan Sensors
Section
Enable
AP to Sensor Ratio
Other Section
Save Region as Walls
Update Environment
and Data Rate
5. When you are finished selecting the desired options, select OK.

Tweaking a Planning Region

If the planning layout does not meet your expectations, you can edit by right-clicking within the region to see the
following options:
304 | Using VisualRF
Description
The type of AP used in this planning region.
Whether they PHY is set to 11n or no radio.
Transmit power of the APs.
Gain of the APs.
EIRP of the APs.
A range from 1-4 that best describes whether the environment is related to an office space,
cubicles, offices, or concrete. Decimal points are allowed.
Plan Coverage by Speed or Signal.
Plan for location accuracy. This mode will result in additional APs placed near the edge of the
region to aid in location calculation.
Number of APs to place in the planning region.
Whether to enable planning by user capacity.
Set the anticipated number of clients that will be stationed in a region.
The maximum number of clients supported by each radio.
Whether to enable to plan sensors into the region.
Specify the number of sensors per AP to use when planning the region.
Whether to save the edges of the planning region as walls.
Whether to update the environment and data rate in case of changes.
Dell PowerConnect W-AirWave 7.6 | User Guide