Dell PowerConnect W-AirWave 7.6 User Manual page 165

Table 87 describes the columns in this image.
Table 87:
Groups > Templates Fields and Default Values
Setting Description
When applicable, this section lists devices that are active on the network with no template available for the
Notes respective firmware. Select the link from such a note to launch the Add Template configuration page for
that device.
Name Displays the template name.
Displays the template that applies to APs or devices of the specified type. If vendor (Any Model) is selected,
the template applies to all models from that vendor that do not have a version specific template defined. If
Device Type
there are two templates that might apply to a device, the template with the most restrictions takes
precedence.
Status Displays the status of the template.
Fetch Date Sets the date that the template was originally fetched from a device.
Designates that the template only applies to APs running the version of firmware specified. If the restriction
is None, then the template applies to all the devices of the specified type in the group. If there are two
Version
templates that might apply to a device the template with the most restrictions takes precedence. If there is a
Restriction
template that matches a devices firmware it will be used instead of a template that does not have a version
restriction.
3. To create a new template and add it to the AirWave template inventory, go to the Groups > List page, and
select the group name, and the Details page appears. Select Templates, then Add.
4. Complete the configurations illustrated in
Figure 113:
Groups > Templates > Add Template Page Illustration
The settings for the Add a Template page are described in
Group.
Dell PowerConnect W-AirWave 7.6 | User Guide
Figure 113.
Table 88. Note that the fields can vary based on the
Creating and Using Templates | 153