Setting A Maintenance Window For A Device - Dell PowerConnect W-AirWave 7.6 User Manual

Setting
SSL Certificate
Extra Device
Commands
switch_command
6. For Cisco WLC devices, go to the interfaces section of the APs/Devices > Manage page. Select Add new
Interface to add another controller interface, or select the pencil icon to edit an existing controller interface.
Table 84 describes the settings and default values. For detailed descriptions of Cisco WLC devices supported by
AirWave, refer to the Cisco WLC product documentation.
Table 84:
APs/Devices > Manage > Interface Fields and Descriptions for Cisco WLC Devices
Field
Name
VLAN ID
Port
IP Address
Subnet Mask
Gateway
Primary and
Secondary DHCP
Servers
Guest LAN
Quarantine VLAN ID
Dynamic Device
Management

Setting a Maintenance Window for a Device

AirWave can automate the manual action of putting multiple devices into Manage mode at once so that changes
can be applied, and after the maintenance period is over, the devices automatically revert to Monitor-Only mode.
Maintenance windows can be set as a one-time or recurring event on the APs/Devices > Manage and Groups >
Basic pages. You can also use the Modify Devices link to add or delete maintenance windows to or from multiple
138 | Discovering, Adding, and Managing Devices
Default Device Type
None Cisco IOS
None Cisco IOS
Cisco Catalyst
None
switches
Default Description
None The name of the interface on the controller.
None The VLAN ID for the interface on the controller.
None The port on the controller to access the interface.
None The IP address of the controller.
None The subnet mask for the controller.
None The controller's gateway.
None The DHCP servers for the controller.
Disabled Indicates a guest LAN.
Disabled Enabled indicates it is a quarantine VLAN; used only for H-REAP-associated clients.
When enabled, makes the interface an AP-manager interface. Cisco calls this feature
Enabled
Dynamic AP Management.
Description
WDS APs.
AirWave will read the SSL Certificate off of the AP when it comes UP
in AirWave. The information in this field will defines what will be used
in place of %certificate%.
Defines the lines that will replace the %ap_include_1% variable in the
IOS template. This field allows for unique commands to be run on
individual APs. If you have any settings that are unique per AP like a
MOTD you can set them here.
Defines lines included for each of the members in the stack. This field
appears only on the master's Manage page. The information in this
field will determine what is used in place of the %switch_command%
variable.
Dell PowerConnect W-AirWave 7.6 | User Guide