Dell PowerConnect W-AirWave 7.6 User Manual page 63

Figure 30:
AMP Setup > WLSE > Add New WLSE Page Illustration
Perform the following steps for optional configuration of AirWave for support of Cisco WLSE rogue scanning.
1. To add a Cisco WLSE server to AirWave , navigate to the AMP Setup > WLSE page and select Add. Complete
the fields in this page.
Table 34:
AMP Setup > WLSE Fields and Default Values
Setting
Hostname/IP Address
Protocol
Port
Username
Password
Poll for AP Discovery;
Poll for Rogue Discovery
Polling Period
Dell PowerConnect W-AirWave 7.6 | User Guide
Table 34 describes the settings and default values.
Default Description
Designates the IP address or DNS Hostname for the WLSE server, which must
None
already be configured on the Cisco WLSE server.
HTTP Specify whether to use HTTP or HTTPS when polling the WLSE.
1741 Defines the port AirWave uses to communicate with the WLSE server.
Defines the username AirWave uses to communicate with the WLSE server.
The username and password must be configured the same way on the WLSE
server and on AirWave.
The user needs permission to display faults to discover rogues and inventory
None
API (XML API) to discover manageable APs. As derived from a Cisco
limitation, only credentials with alphanumeric characters (that have only
letters and numbers, not other symbols) allow AirWave to pull the necessary
XML APIs.
Defines the password AirWave uses to communicate with the WLSE server.
The username and password must be configured the same way on the WLSE
server and on AirWave.
None
As derived from a Cisco limitation, only credentials with alphanumeric
characters (that have only letters and numbers, not other symbols) allow
AirWave to pull the necessary XML APIs.
Sets the method by which AirWave uses WLSE to poll for discovery of new
Yes
APs and/or new rogue devices on the network.
Determines how frequently AirWave polls WLSE to gather rogue scanning
10 minutes
data.
Configuring AirWave | 51