Configuring Device Interfaces For Switches - Dell PowerConnect W-AirWave 7.6 User Manual

selected devices at once. Additionally, this feature can be used on the Master Console to set maintenance windows
for multiple AirWaves.
To set a maintenance window for a single device, follow these steps:
1. Select a device and navigate to the APs/Devices > Manage page for a device.
2. At the bottom of the page, locate the Maintenance Windows section.
3. Select Add New AP Maintenance Window.
Figure 99:
Add New Maintenance Window in APs/Devices > Manage page
4. Enter a name for the maintenance window.
5. In the Occurs field, specify whether the maintenance window should occur one time, or daily, weekly, monthly, or
annually. Additional options may display based on the selected value. For example, if you select monthly, the you
will be prompted to specify the day of the month for the recurrance.
6. Set the desired start time and the duration (in minutes) of the maintenance window.
7. Select Add.

Configuring Device Interfaces for Switches

When you go to the APs/Devices > Interfaces page for a switch, you can add a Virtual interface by selecting Add
and entering the appropriate information in the page that then appears, as shown in
Figure 100:
Add Virtual Interfaces Page for Wired Devices
.
New physical and virtual interfaces are discovered using SNMP polling as described in
page 102. To refresh and reload all current interface information from a device, select Import Interfaces on the
bottom of the page as shown in
Dell PowerConnect W-AirWave 7.6 | User Guide
Figure 101.
Figure 100.
"SNMP/HTTP Scanning" on
Discovering, Adding, and Managing Devices | 139