Amp Features; External Logging Settings - Dell PowerConnect W-AirWave 7.6 User Manual

Table 7:
AMP Setup > General > Device Configuration Section Fields and Default Values
Setting
Guest User
Configuration
Allow WMS Offload
configuration in
monitor-only mode
Allow disconnecting
users while in
monitor-only mode
Use Global Dell
PowerConnect W
Configuration

AMP Features

Locate the AMP Features section and adjust settings to enable or disable VisualRF and RAPIDS.
these settings and default values
Table 8:
AMP Setup > General > AMP Features Fields and Default Values
Setting
Display VisualRF
Display RAPIDS
Hide setup pages from
non-admin users
Allow role based
report visibility

External Logging Settings

Locate the External Logging section and adjust settings to send audit and system events to an external syslog server.
Table 9 describes these settings and default values. You can also send a test message using the Send Test Message
20 | Configuring AirWave
Default Description
Enables or prevents guest users to/from pushing configurations to devices.
Disabled Options are Disabled (default), Enabled for Devices in Manage (Read/Write),
Enabled for all Devices.
When Yes is selected, you can enable the ArubaOS WMS offload feature on
the Groups > Basic page for WLAN switches in Monitor Only mode. Enabling
No
WMS offload does not cause a controller to reboot. This option is supported
only for Aruba and Dell PowerConnect W-Series devices.
Sets whether you can deauthenticate a user for a device in monitor-only mode.
No If set to No, the Deauthenticate Client button for in a Clients > Client Detail
page is enabled only for Managed devices.
Enables Dell configuration profile settings to be globally configured and then
assigned to device groups. If disabled, settings can be defined entirely within
Groups > Dell PowerConnect W Config instead of globally.
NOTE: Changing this setting may require importing configuration on your
devices. When an existing Dell PowerConnect W-Series configuration setup is
to be converted from global to group, follow these steps:
No 1. Set all the devices to Monitor Only mode before setting the flag.
2. Each device Group will need to have an import performed from the Audit
page of a controller in the AMP group.
3. All of the thin APs need to have their settings imported after the device
group settings have finished importing.
4. If the devices were set to Monitor Only mode, set them back to Managed
mode.
.
Default Description
Enable or disable the VisualRF navigation tab.
No
No Enable or disable the RAPIDS navigation tab.
Restrict access to following pages to users with the AMP Administration role only:
VisualRF > Setup
l
AMP Setup > NMS
l
Yes RAPIDS > Score Override
l
RAPIDS > Rules
l
RAPIDS > Setup
l
System > Triggers
l
Enable or disable role-based reporting in AMP. When disabled, reports can only be
Yes
generated with by-subject visibility.
Table 8
Dell PowerConnect W-AirWave 7.6 | User Guide
describes