Dell PowerConnect W-AirWave 7.6 User Manual page 76

Setting
Regulatory
Domain
Timezone
Allow One-to-
One NAT
Audit
Configuration
on Devices
Is Global Group
Use Global
Group
4. Complete the SNMP Polling Periods section. The information in this section overrides default settings.
40 describes the SNMP polling settings.
Table 40:
SNMP Polling Periods Fields and Default Values
Setting
Up/Down Status Polling
Period
Override Polling Period for
Other Services
AP Interface Polling Period
Client Data Polling Period
Thin AP Discovery Polling
Period
Device-to-Device link
Polling Period
802.11 Counters Polling
Period
Rogue AP and Device
Location Data Polling Period
64 | Configuring and Using Device Groups
Default Description
Sets the regulatory domain in AirWave, limiting the selectable channels for APs in the
United States
group.
Allows group configuration changes to be scheduled relative to the time zone in which
AMP System
the devices are located. This setting is used for scheduling group-level configuration
Time
changes.
Allows AirWave to talk to the devices on a different IP address than the one configured
on the device.
No
NOTE: If enabled, the LAN IP Address listed on the AP/Devices > Manage configuration
page under the Settings area is different than the IP Address under the Device
Communication area.
Auditing and pushing of configuration to devices can be disabled on all the devices in
Yes the group. Once disabled, all the devices in the groups will not be counted towards
mismatched devices.
If specified as Yes, then this group can be selected in the Use Global Group drop down
No
menu for future group configurations.
When enabled, this field allows you to define the device group to be a Global Group.
No
"Using Global Groups for Group Configuration" on page
Refer to
Default Description
Sets time between Up/Down SNMP polling for each device in the group.
The Group SNMP Polling Interval overrides the global parameter configured
5 minutes
on the Device Setup > Communication page. An initial polling interval of 5
minutes is best for most networks.
Enables or disables overriding the base SNMP Polling Period. If you select
No Yes, the other settings in the SNMP Polling Periods section are activated, and
you can override default values.
Sets the interval at which AirWave polls for radio monitoring and bandwidth
10 minutes
being used by a device.
10 minutes Sets time between SNMP polls for client data for devices in the group.
Sets time between SNMP polls for Thin AP Device Discovery. Controllers are
15 minutes
the only devices affected by this polling interval.
Sets time between SNMP polls for Device-to-Device link polling. Mesh APs
5 minutes
are the only devices affected by this polling interval.
15 minutes Sets time between SNMP polls for 802.11 Counter information.
Sets time between SNMP polls for Rogue AP and Device Location Data
30 minutes
polling.
98.
Dell PowerConnect W-AirWave 7.6 | User Guide
Table