Flash drive
The PowerEdge M630 system supports internal optional USB, internal optional SD card and optional vFlash card (with integrated iDRAC8
Enterprise).
Ports and connectors specifications
USB ports
The PowerEdge M630 system supports:
•
One USB 2.0-compliant and one USB 3.0-compliant port on the front panel
•
Internal USB 2.0-compliant port
The following table provides more information about the USB specifications:
Table 9. USB specifications
System
PowerEdge M630
Internal Dual SD Module
The PowerEdge M630 system supports two SD card slots and a USB interface dedicated for the embedded hypervisor. This card offers
the following features:
•
Dual card operation — maintains a mirrored configuration by using SD cards in both slots and provides redundancy.
•
Single card operation — single card operation is supported, but without redundancy.
Video specifications
The PowerEdge M630 system supports Matrox G200 VGA controller integrated with iDRAC and 2 GB shared with iDRAC application
memory.
Environmental specifications
NOTE:
For additional information about environmental measurements for specific system configurations, see Dell.com/
environmental_datasheets.
Table 10. Temperature specifications
Temperature
Storage
Continuous operation (for altitude less than 950 m or 3117 ft)
Fresh air
Maximum temperature gradient (operating and storage)
18
Technical specifications
Front panel
One 4-pin, USB 2.0-compliant and one 4-
pin, USB 3.0-compliant
Specifications
–40°C to 65°C (–40°F to 149°F)
10°C to 35°C (50°F to 95°F) with no direct sunlight on the
equipment.
For information about fresh air, see Expanded Operating
Temperature section.
20°C/h (36°F/h)
Internal
•
Two internal SD cards dedicated for the
hypervisor
•
One SD card dedicated for future vFlash
support