Table of Contents
Advertisement
NOTE:
The slot is keyed to ensure correct insertion of the card.
2. Press the card into the card slot to lock it into place.
NOTE:
Temporarily label each SD card with its corresponding slot before removal.
Figure 50. Installing the internal MicroSD card
Next steps
Follow the procedure listed in
IDSDM
Removing the optional internal dual SD module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Install the air
shroud.
NOTE:
The procedure to remove IDSDM and the BOSS M.2 card is the same.
Steps
1. Pressing the release latches, lift the drive backplane only until the guide pins on the drive cage disengage from the guides on
the drive backplane.
2. Using the Phillips #2 screwdriver, loosen the retention screw that connects the internal dual SD module (IDSDM) to the
system board.
3. Lift the release tab that secures the IDSDM to the system board.
4. Holding both ends of the IDSDM, lift the IDSDM out of the IDSDM/BOSS M.2 connector on the system board.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
57
Advertisement
Table of Contents
