Defining Trap Management
The Defining Trap Management section contains the following pages:
•
Defining Trap Settings
•
Configuring Station Management
•
Defining SNMP Filter Settings
Defining Trap Settings
The Trap Settings Page contains parameters for defining SNMP notification parameters.
The Trap Settings Page contains the following fields:
•
Enable SNMP Notification — Specifies whether the device can send SNMP notifications.
The possible field values are:
–
Checked — Enables SNMP notifications.
–
Unchecked — Disables SNMP notifications.
•
Enable Authentication Notification — Specifies whether SNMP authentication failure
notification is enabled on the device. The possible field values are:
–
Checked — Enables the device to send authentication failure notifications.
–
Unchecked — Disables the device from sending authentication failure notifications.
Chapter 12: Configuring SNMP
Defining Trap Management
SFE1000P Gigabit Ethernet Switch Administration Guide
Trap Settings Page
Chapter
12
147