–
Rapid STP — Indicates that Rapid STP is enabled on the port.
•
Fast Link — Indicates if Fast Link is enabled or disabled for the port or LAG. If Fast Link is
enabled for a port, the port is automatically placed in the forwarding state.
–
Enable — Fast Link is enabled.
–
Disable — Fast Link is disabled.
–
Auto — Fast Link mode is enabled a few seconds after the interface becomes active.
•
Port Status — Indicates the RSTP status on the specific port. The possible field values are:
–
Disabled — Indicates that STP is currently disabled on the port. The port forwards traffic
while learning MAC addresses.
–
Blocking — Indicates that the port is currently blocked and cannot forward traffic or
learn MAC addresses.
–
Listening — Indicates that the port is in Listening mode. The port cannot forward traffic
nor can it learn MAC addresses.
–
Learning — Indicates that the port is in Learning mode. The port cannot forward traffic,
however it can learn new MAC addresses.
–
Forwarding — Indicates that the port is in Forwarding mode. The port can forward
traffic and learn new MAC addresses.
•
Point-to-Point Operational Status — Indicates the Point-to-Point operating state.
•
Activate Protocol Migration — Click the Activate button to run a Protocol Migration Test.
The test identifies the STP mode of the interface connected to the selected interface.
Chapter 11: Configuring Spanning Tree
Defining Rapid Spanning Tree
SFE1000P Gigabit Ethernet Switch Administration Guide
Chapter
11
123