Table of Contents
Advertisement
transmission rate, duplex mode and flow control (the flow control default is disabled)
abilities to its partner.
•
Current Auto Negotiation — The current Auto Negotiation setting.
•
Admin Advertisement — Specifies the capabilities to be advertised by the LAG. The
possible field values are:
–
Max Capability — Indicates that all LAG speeds and Duplex mode settings can be
accepted.
–
10 Half — Indicates that the LAG is advertising a 10 Mbps speed and half Duplex mode
setting.
–
10 Full — Indicates that the LAG is advertising a 10 Mbps speed and full Duplex mode
setting.
–
100 Half — Indicates that the LAG is advertising a 100 Mbps speed and half Duplex
mode setting.
–
100 Full — Indicates that the LAG is advertising a 100 Mbps speed and full Duplex
mode setting.
–
1000 Full — Indicates that the LAG is advertising a 1000 Mbps speed and full Duplex
mode setting.
•
Current Advertisement — The LAG advertises its capabilities to its neighbor LAG to start the
negotiation process. The possible field values are those specified in the Admin
Advertisement field.
•
Neighbor Advertisement — The neighbor LAG (the LAG to which the selected interface is
connected) advertises its capabilities to the LAG to start the negotiation process. The possible
values are those specified in the Admin Advertisement field.
•
Admin Speed — The configured speed at which the LAG is operating.
•
Current LAG Speed — The current speed at which the LAG is operating.
•
Admin Flow Control — Enables or disables flow control or enables the auto negotiation of
flow control on the LAG.
•
Current Flow Control — The user-designated Flow Control setting.
•
PVE — Indicates if this LAG's ports are protected by an uplink, so that the forwarding
decisions are overwritten by those of the ports that protect them.
Chapter 6: Configuring Device Interfaces
Defining LAG Settings
SFE1000P Gigabit Ethernet Switch Administration Guide
Chapter
6
80
Hide quick links:
Advertisement
Table of Contents
