Add Arp - Cisco Linksys SFE1000P Reference Manual

– All — All ARP entries are cleared.
– Dynamic — Only dynamic ARP entries are cleared.
– Static — Only static ARP entries are cleared.
ARP Entries
• Interface — Indicates the interface connected to the device.
• IP Address — Indicates the station IP address, which is associated with the MAC address
filled in below.
• MAC Address — Indicates the station MAC address, which is associated in the ARP table
with the IP address.
• Status — Indicates the ARP Table entry status. Possible field values are:
– Dynamic — Indicates the ARP entry was learned dynamically.
– Static — Indicates the ARP entry is a static entry.

Add ARP

The Add ARP Page allows you to enter ARP addresses.
The Add ARP Page contains the following fields:
• VLAN — Indicates the ARP-enabled interface.
• IP Address — Indicates the station IP address, which is associated with the MAC address
filled in below.
• MAC Address — Indicates the station MAC address, which is associated in the ARP table
with the IP address.
Chapter 8: Configuring IP Information
Configuring Layer 2 IP Addresses
SFE1000P Gigabit Ethernet Switch Administration Guide
Add ARP Page
Chapter
8
102