•
LAG — Indicates the LAG to which the port belongs. If a port is a member of a LAG, the
LAG settings override the port settings.
Modifying Interface Settings
The Edit Interface Settings Page contains the following fields:
•
Port — Indicates the port number on which Spanning Tree is configured.
•
STP — Indicates if STP is enable on the port. The possible field values are:
–
Enable — Indicates that STP is enabled on the port.
–
Disable — Indicates that STP is disabled on the port.
•
Port Fast — Indicates if Fast Link is enabled on the port. If Fast Link mode is enabled for a
port, the Port State is automatically placed in the Forwarding state when the port link is up.
Fast Link optimizes the STP protocol convergence. STP convergence can take 30-60 seconds
in large networks.The possible values are:
–
Enable — Port Fast is enabled.
–
Disable — Port Fast is disabled.
–
Auto — Port Fast mode is enabled a few seconds after the interface becomes active.
•
Enable Root Guard — Enable the prevention of a devices outside the network core from
being assigned the spanning tree root.
Chapter 11: Configuring Spanning Tree
Defining Interface Settings
SFE1000P Gigabit Ethernet Switch Administration Guide
Edit Interface Settings Page
Chapter
11
120