Defining Dos Prevention; Global Settings - Cisco Linksys SFE1000P Reference Manual

Defining DoS Prevention

The DoS Prevention section contains the following pages:
•

Global Settings

• Defining Martian Addresses
Global Settings
The Global Settings Page contains the following fields:
• Security Suite Status — Indicates if DOS security is enabled on the device. The possible field
values are:
– Enable — Enables DOS security.
– Disable — Disables DOS security on the device. This is the default value.
• Denial of Service Protection — Indicates if any of the services listed below are enabled. If
the service protection is disabled, the Stacheldraht Distribution, Invasor Trojan, and Back
Office Trojan fields are disabled.
– Stacheldraht Distribution — Discards TCP packets with source TCP port equal to 16660.
– Invasor Trojan — Discards TCP packets with destination TCP port equal to 2140 and
source TCP port equal to 1024.
– Back Orifice Trojan — Discards UDP packets with destination UDP port equal to 31337
and source UDP port equal to 1024.
Chapter 5: Configuring Device Security
Defining DoS Prevention
SFE1000P Gigabit Ethernet Switch Reference Guide
Global Settings Page
Chapter
5
67