Cisco Linksys SFE1000P Reference Manual page 45

• Management Method — Defines the management method for which the rule is defined.
Users with this access profile can access the device using the management method selected.
The possible field values are:
– All — Assigns all management methods to the rule.
– Telnet — Assigns Telnet access to the rule. If selected, users accessing the device using
Telnet meeting access profile criteria are permitted or denied access to the device.
– SNMP — Assigns SNMP access to the rule. If selected, users accessing the device using
SNMP meeting access profile criteria are permitted or denied access to the device.
– HTTP — Assigns HTTP access to the rule. If selected, users accessing the device using
HTTP meeting access profile criteria are permitted or denied access to the device.
– Secure HTTP (SSL) — Assigns HTTPS access to the rule. If selected, users accessing the
device using HTTPS meeting access profile criteria are permitted or denied access to the
device.
– Secure Telnet (SSH) — Assigns SSH access to the rule. If selected, users accessing the
device using Telnet meeting access profile criteria are permitted or denied access to the
device.
• Interface — Defines the interface on which the access profile is defined. The possible field
values are:
– Port — Specifies the port on which the access profile is defined.
– LAG — Specifies the LAG on which the access profile is defined.
– VLAN — Specifies the VLAN on which the access profile is defined.
• Source IP Address — Defines the interface source IP address to which the access profile
applies. The Source IP Address field is valid for a subnetwork.
– Network Mask — Determines what subnet the source IP Address belongs to in the
network.
– Prefix Length — Defines the number of bits that comprise the source IP address prefix, or
the network mask of the source IP address.
• Action — Defines the action attached to the rule. The possible field values are:
– Permit — Permits access to the device.
– Deny — Denies access to the device. This is the default.
Chapter 5: Configuring Device Security
Defining Access Method
SFE1000P Gigabit Ethernet Switch Reference Guide
Chapter
5
37