Add Multicast Group - Cisco Linksys SFE1000P Reference Manual

– Checked — Enables Multicast Filtering on the device.
– Unchecked — Disables Multicast Filtering on the device.
• VLAN ID — Specifies the VLAN ID.
• Bridge Multicast Address — Identifies the Multicast group MAC address or IP address.
• Ports — Displays the Multicast Group status of all of the device's ports.
• LAGs — Displays the Multicast Group status of all of the device's LAGs.
• Interface — Displays the interface on which the Multicast service is configured.
• Interface Status — Displays the interface status. The options are as follows:
– Static — Attaches the interface to the Multicast group as static member in the Static Row.
The interface has joined the Multicast group statically in the Current Row.
– Forbidden — Forbidden interfaces are not included the Multicast group, even if IGMP
snooping designated the interface to join a Multicast group.
– Dynamic — Attaches the interface dynamically to the Multicast group.
– Excluded — The interface is not part of a Multicast group.

Add Multicast Group

The Add Multicast Group Page contains the following fields:
• VLAN ID — Displays the VLAN ID.
• Bridge Multicast IP Address — Displays the IP address attached to the Multicast Group.
• Bridge Multicast MAC Address — Displays the MAC address attached to the Multicast
Group.
Chapter 10: Configuring Multicast Forwarding
Defining Multicast Bridging Groups
SFE1000P Gigabit Ethernet Switch Administration Guide
Add Multicast Group Page
Chapter
10
111