Cisco Linksys SFE1000P Reference Manual page 57

– Checked — Enables using a Guest VLAN for unauthorized ports. If a Guest VLAN is
enabled, the unauthorized port automatically joins the VLAN selected in the VLAN List
field.
– Unchecked — Disables port-based authentication on the device. This is the default.
• Enable Periodic Reauthentication — Permits port reauthentication during the specified
Reauthentication Period (see below). The possible field values are:
– Checked — Enables immediate port reauthentication. This is the default value.
– Unchecked — Disables port reauthentication.
• Reauthentication Period — Specifies the number of seconds in which the selected port is
reauthenticated (Range: 300-4294967295). The field default is 3600 seconds.
• Reauthenticate Now — Specifies that authentication is applied on the device when the
Apply button is pressed.
– Checked — Enables immediate port reauthentication.
– Unchecked — Port authentication according to the Reauthentication settings above.
• Authenticator State — Specifies the port authorization state. The possible field values are as
follows:
– Force-Authorized — The controlled port state is set to Force-Authorized (forward
traffic).
– Force-Unauthorized — The controlled port state is set to Force-Unauthorized (discard
traffic).
• Quiet Period — Specifies the number of seconds that the switch remains in the quiet state
following a failed authentication exchange (Range: 0-65535).
• Resending EAP — Specifies the number of seconds that the switch waits for a response to an
EAP - request/identity frame, from the supplicant (client), before resending the request.
• Max EAP Requests — The total amount of EAP requests sent. If a response is not received
after the defined period, the authentication process is restarted. The field default is 2 retries.
• Supplicant Timeout — Displays the number of seconds that lapses before EAP requests are
resent to the supplicant (Range: 1-65535). The field default is 30 seconds.
• Server Timeout — Specifies the number of seconds that lapses before the switch resends a
request to the authentication server (Range: 1-65535). The field default is 30 seconds.
• Termination Cause — Indicates the reason for which the port authentication was terminated,
if applicable.
Chapter 5: Configuring Device Security
Defining 802.1x
SFE1000P Gigabit Ethernet Switch Reference Guide
Chapter
5
49