Table of Contents
Advertisement
Defining Interface Settings
The VLAN Interface Setting Page provides parameters for managing ports that are part of a VLAN.
The port default VLAN ID (PVID) is configured on the VLAN Port Settings page. All untagged packets
arriving to the device are tagged by the ports PVID.
The VLAN Interface Setting Page contains the following fields:
•
Port — Indicates that ports are described in the page.
•
LAG — Indicates that LAGs are described in the page.
•
Interface — The port or LAG number included in the VLAN.
•
Interface VLAN Mode — Indicates the interface membership status in the VLAN. The
possible values are:
–
General — The port belongs to VLANs, and each VLAN is user-defined as tagged or
untagged (full 802.1Q mode).
–
Access — The port belongs to a single untagged VLAN. When a port is in Access mode,
the packet types which are accepted on the port (packet type) cannot be designated. It is
also not possible to enable/disable ingress filtering on an access port.
–
Trunk — The port belongs to VLANs in which all ports are tagged (except for an
optional single native VLAN).
•
PVID — Assigns a VLAN ID to untagged packets. The possible values are 2 to 4092, and
4095. Packets classified to the Discard VLAN are dropped.
•
Frame Type — Packet type accepted on the port. Possible values are:
–
Admit Tag Only — Indicates that only tagged packets are accepted on the port.
Chapter 7: Configuring VLANs
Defining Interface Settings
SFE1000P Gigabit Ethernet Switch Administration Guide
Interface Setting Page
Chapter
7
88
Hide quick links:
Advertisement
Table of Contents
